User Guide

FIC MB05W Service Manual
FIC MB05 Service Manual 1-97
The following System Top Unit Assembly includes the following major Field Replaceable
Units/parts (FRUs):
• Glidepad Touch Pad Module Assembly
The touch pad (glide pad) pointing device module is assembled at the underside of the
top cover with the sensor pad exposed on the top. The assembly comprises of the glide
pad board, the glide pad converter board, the select buttons bracket casing, the insulator
sheet, the glide pad FPC cable, and the glidepad wire cable. The glide pad board is
assembled just underneath the select button assembly. It provides a FPC cable
connector for the mother board.
• Keyboard Panel Assembly
The keyboard is assembled on top of the system unit and connected to the main board’s
keyboard FPC type connector. The keyboard is also secured on the system’s top unit
casing. There are no screws attached to the keyboard.
• Heat Plate and Fan Exhaust Unit
The Fan Exhaust unit is assembled on the upper-right side of the system unit. It
comprises of a heat plate and one fan. There are seven screws securing the heat plate to
the CPU module inserted on the motherboard. The exhaust fan is secured beside the
heat plate.
• Keyboard Cover Assembly
The keyboard cover is a thin bracket for holding the keyboard as well as covering the
base unit. It is also includes the power button, easy buttons, and status LED cover
moldings.
The following System Base Unit Assembly includes the following major Field Replaceable
Units/parts (FRUs):
• Battery Pack
This is one of more easily replaceable parts. The battery pack is found on the right side
on the base unit and can be easily removed by pressing the latch underneath the unit and
pulling the battery on its handle. The battery pack is replaced as a whole and must not be
opened for repair.
• Hard Disk Drive Module
The Hard Disk Drive is attached on the lower-left side of the system base unit located just
below the keyboard. The HDD is secured by only one screw. The HDD module is a 2.5-
inch hard disk drive with a maximum height of 9.5mm. The hard drive module assembly
is attached to the motherboard through the HDD connector.
• CD-ROM / DVD-ROM Drive Assembly
The CD-ROM / DVD-ROM / Drive Assembly is attached on the right side of the base unit
and is lock with one latch.
• CPU
The Pentium socket is found on the top right part of the motherboard. You will need a flat
screwdriver and CPU tooling for removing or installing the CPU. Refer to Chapter 2 on
how to install and upgrade the CPU.
• Speaker Assembly
The internal speakers of the notebook are assembled into front side of the system. They
are secured into a slot and speaker cable connector is attached into the main board.
PDF created with FinePrint pdfFactory trial version http://www.fineprint.com