User Guide

Installation and Upgrade
FIC A985 Service Manual 2-9
Figure 2-8 Insert Memory Module
5. To remove a SODIMM, press the locking tabs away from the sides of the module until
the module pops up. Then, remove the SODIMM.
6. Reassemble the notebook components as follows.
−
Put the DIMM door back.
− Replace the screw and turn the system over.
2.3.6 Removing the Internal Hard Disk Drive
The notebook provides a built-in hard disk for the primary IDE controller. The HDD is an
industry standard 2.5” IDE disk drive with a maximum height of 9.5mm, and can be upgraded
with another standard 2.5” HDD with a maximum height of 9.5mm.
1. Find out the built-in hard disk secured with two screws at the right corner of the hard disk.
Remove this screw and carefully pull the hard disk module from the connector.
2 Screws
Figure 2-9 Remove Two Screws Securing HDD
2. Remove four screws of frame HDD bracket plate. Two small ones of them are at the front
side, and others are at the both sides
45 ~ 60 degrees
PDF created with FinePrint pdfFactory trial version http://www.fineprint.com