User Guide

Hardware Functional Overview
FIC A440 Series Service Manual 4-36
4.10.2 Advanced Menu Default & Options
PhoenixBIOS Setup Utility
Main Advanced Security Power Boot Exit
Item Specification Help
PS/2 Mouse : [Auto]
Installed O/S : [WinME / Win200]
Start-up Screen : [Disabled]
Serial port : [Auto]
Infrared port : [Auto]
Mode : [IrDA]
Parallel port : [Auto]
Mode : [EPP]
Selects Power on state
for NumLock.
F1 Help  Select Item -/+ Change Values F9 Setup Defaults
ESC Exit  Select Menu Enter Select Sub-Menu F10 Save and Exit
PS/2 Mouse [Auto] /
[Both]/
[Disabled]
‘Disabled’ prevents any installed PS/2 mouse from
functioning, but frees up IRQ12. [Both] allows both internal
and external PS/2 mouse to be active.[Auto] will only allow
the external PS/2 mouse to be active if it is detected.
Installed O/S [WinME /
Win2000] /
[Other]
Select the operating system installed on your system which
you will use most commonly.
Note: An incorrect setting can cause some operating systems
to display unexpected behavior.
Start-up Screen [Enabled] /
[Disabled]
Select boot screen using options:
[Enabled] – Boot with POST screen.
[Disabled] – Boot with black screen.
Serial port [Auto] /
[Disabled]
Configure serial port A using options:
Disabled - No configuration,
Auto - BIOS or OS chooses configuration.
Infrared port [Auto] /
[Disabled]
Configure Infrared port using options:
Disabled - No configuration,
Auto - BIOS or OS chooses configuration..
Parallel port [Auto] /
[Disabled]
Configure parallel port using options:
Disabled - No configuration,
Auto - BIOS or OS chooses configuration,
Mode [Uni-directional]
/[ECP] / [EPP]
Set the mode for the parallel port using options:
Uni-directional,.ECP, EPP.