Hardware Guide

Reproduction forbidden without Fibocom Wireless Inc. written authorization - All rights reserved.
FIBOCOM MC610 Series Hardware Guide 43/71
Figure 3-16 Reference design diagram of network indicator for MC610 series modules
3.8 Low Power Mode
3.8.1 Sleep Mode
The sleep mode can be activated by module by the following ways:
1. The ATS24 command makes the module to sleep, and the wake-up keeping time depends on
</value> in the command ATS24 = [<value>]. Send the AT command: ATS24=2. The module will
enter the Sleep mode in 2 s, and the setting will not be saved after the module is powered down.
2. Set the sleep mode through AT+GTSET="LPMMODE". x set and save the settings after power
failure.
x=1 --- level wakeup, WAKEUP_IN indicates that sleep is not allowed at low level;
x=2 --- level wakeup, WAKEUP_IN indicates that sleep is not allowed at high level;