Installation Guide

ManualsBrandsFiberon ManualsDeck Railing KitsSEC S W 8SKD 36AB

Center the hole pattern in the bottom rail

between the posts. Transfer length and

angle to the top rail and cut both top and

bottom rails. When aligning the hole pattern,

transferring length, and cutting angles on

the H-bar, remember to subtract 7/32-in.

from each end to allow for top brackets.

Secure with supplied #10 x 2-1/2-in. self-

drilling screws. Do not over tighten.

Ensure that the bottom rail is positioned

correctly prior to cutting the bottom rail

angle for installation. The bottom rail has an

aligning feature on the top which should be

on the yard side of the rail opposite to the

deck side.

Aligning feature

Yard Side Deck Side

For angled line installation, the line brackets

must be installed with the angled edge on

the deck side of the railing.

Note: This is opposite of what is indicated

on the line bracket for basic line railing

installation.

The template can still be used to locate the

height of the line bracket. The side-to-side

alignment needs to be approximately 7/32-

in. – 1/4-in. off-centered from the deck side

of the railing for a full 45 degree installation.

Note: If the bracket is not offset slightly, the

top rail may overhang the corner post face

and extend into the corner chamfer.

7/32-in. - 1/4-in.

Deck Side Yard Side

Symmetry Railing

Installation Instructions -

6-ft. and 8-ft. Line (cont.)

The most recent installation instructions can be found on our website.

Please visit https://www.berondecking.com/resources/installation-instructions or call Consumer and Technical Support at 800-573-8841.

Secure the top brackets with the supplied #10

x 2-1/2-in. screws.

Using supplied 1-7/8-in. screws, secure

the top rail starting as close to the post as

possible. Space the remaining screws evenly.

Complete the assembly by gluing the post

caps in place with a quality exterior-grade

adhesive.

Position the top rail over the inll assembly,

and carefully lower into place.

Note: Angled installations require a

minimum 5x5 post.

Symmetry

Railing Installation Instructions - Angled Line