Installation Guide
Control Panel Instructions (pg 1)
Power
Turns the system power o and on. When the system power is o, the LCD display will be blank and the only
button that will function is the power button. When the system power is on, the LCD display will show the current
mode or function that is active.
Mode and LCD Display
Pressing or holding in the mode button will cycle through the dierent modes settings. The mode settings are1h,
2h, 3h, 4h, 5h, 6h, 7h, 8h, dd and Ao.
1 to 8 hour timer (1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h)
• Uses the photocell to turn the lights on. When the photocell senses darkness continually for 30 to 40 seconds,
the lights will turn on.
• The lights shut o aer the set time expires (1 hour for1h mode, 2 hours for 2h, etc.).
• Aer the set time expires the lights will remain o.
• Whether the timer has expired or is still active, when the photocell senses light continually for 30 to 40
seconds, the timer will be reset and ready for another cycle. If the lights are on, they will be shut o and the
timer is reset.
Dusk to Dawn (dd)
• Uses the photocell to turn the lights on. When the photocell senses darkness continually for 30 to 40 seconds,
it will turn on the lights.
• The lights will remain on until the photocell senses light continually for 30 to 40 seconds.
• When the photocell senses light continually for 30 to 40 seconds the lights will be shut o and ready for
another cycle.
Always On (Ao)
• The lights are on all the time. The photocell is not used.
Dimmer
• Pressing or holding in the up button (▲) will make the lights brighter. If the lights are full brightness and the
button is pressed again (or held in), the lights will flicker or flash to indicate the lights are at the brightest
setting.
• Pressing or holding in the down button (▼) will make the lights dimmer. If the lights are dimmed to the lowest
setting and the button is pressed again (or held in), the lights will flicker or flash to indicate the lights are at
the dimmest setting.
• The dimmer buttons are only operational when the output lights are on.
continued on reverse side