Installation Guide

Installation Diagrams
How to Connect Product Wiring
Tee Connector
to Harness
Harness to
Output Splitter
Closed Loop Connector to
Tee Connector (Optional)
Harness to
Closed Loop
Connector
(Optional)
Output Splitter to
fixture Lead Wire
Lights
Dome Side Light
Cap Lights
Side / Riser Light Ornamental Side Light
Recessed &
Flush Mount
Lights
Drill hole minimum
1/2 in. from edge
7/8 in. Diameter
Forstner Bit for
Recessed Riser
Permanently secure
cap to post (optional):
Apply a bead of clear exterior
silicone caulking (not supplied)
around the top exterior perimeter
of the post where the Post Cap
Light will be attached. Place the
connected, confirmed working
Post Cap Light onto the post
where sealant was added.
Wiring can be run underneath the deck (above ground) and / or
inside the post / railing where it is hidden from view.
A 1/2 in. diameter hole will be be required to feed the wire through.
1-¼ in. Diameter Forstner
Bit with trim ring and 1 in.
Diameter Forstner Bit without
trim ring for Flush Deck Mount.