Lighting Descriptions Power Photocell Transformer Remote Closed Loop Connector Transformer Tee Connector Plug into 120V GFCI outlet Wiring 2 Output Splitter (2 Male, 1 Female) Male to Female Connections 5 Output Splitter (5 Male, 1 Female) Wire Harnesses (1 Male, 1 Female) 2 End Caps for unused connectors Lights Dome Side Light Flush Mount Light with optional Trim Ring Flat Top Cap Light Pyramid Top Cap Light Side / Riser Light Recessed Riser Light
Installation Diagrams How to Connect Product Wiring Tee Connector to Harness Harness to Output Splitter Closed Loop Connector to Tee Connector (Optional) Lights Output Splitter to fixture Lead Wire Wiring can be run underneath the deck (above ground) and / or inside the post / railing where it is hidden from view. A 1/2 in. diameter hole will be be required to feed the wire through. Drill hole minimum 1/2 in. from edge 7/8 in.
Control Panel Instructions (pg 1) Power Turns the system power off and on. When the system power is off, the LCD display will be blank and the only button that will function is the power button. When the system power is on, the LCD display will show the current mode or function that is active. Mode and LCD Display Pressing or holding in the mode button will cycle through the different modes settings. The mode settings are1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h, dd and Ao.
Control Panel Instructions (pg 2) Pair Pairs a new wireless remote control. To pair a new wireless remote (the included remote is already paired at the factory): • Press and hold the pair button on the transformer. At the same time press and hold the M button on the new remote. The LCD display will show rt to indicate that it is in remote pairing mode. • Continue holding both buttons in for 8 to 10 seconds. When the new remote is paired, the output lights will flash or flicker.
