User's Manual

XGS-PON FGW User Manual

Setup

Q_PPS_DM_018_V1.3

Figure 17: Network provider connection

• Clean the optical connectors of the optical pactchcord, Figure 17, b), of the FiberGateway PON

port, Figure 17, a), and the optical wall socket , Figure 17, before connecting using appropriate

optical connector cleaning material;

• Plug one of the patchcord cleaned SC/APC optical connectors on the Fiber Gateway PON port,

Figure 17, a), observing the alignment mechanism, ( the tooth in the conector must fit into the

groove in the PON port connector: a click indicates the connector is secure into place)

• Plug the other end optical patchcord SC/APC connector on the optical wall socket observing

the alignment mechanism, ( the tooth in the conector must fit into the groove in the optical

wall socket connector: a click indicates the connector is secure into place)

• Accommodate the patchcord excessive length avoiding small bend radius on the patchcord

(30mm minimum bend radius).

4.11.2 Mains connection and power up

• Connect the power adaptor output connector to the 12-VDC power port on the equipment;

• Plug the power adaptor appropriate power cord into an approved 120VAC outlet, Figure 16;

• Switch on the equipment, ON-OFF button

After executing a power-up sequence the equipment will be ready for operation.