User Manual

Table Of Contents

BASIC ACTIVATION

#2: Basic activation

1. Turn the cover counter-clockwise and open it.

2. Remove the battery blocker.

3. Flood Sensor will conrm being powered with a short beep and a

LED blink.

4. Add the device (see “Adding/removing the device” on page 6).

5. Close the cover and turn it clockwise.

6. Place the sensor on a surface prone to ooding. Three electrodes

underneath the device should evenly touch the surface.

NOTE

After completing

installation it is rec-

ommended to test

sensor’s operation

by placing the entire

sensor or its probes’

extension wire onto

water surface.

NOTE

When changing the

Sensor’s location, it’s

recommended to wake

up the device and re-

congure the Z-Wave

network by triple click-

ing the TMP button or

removing and insert-

ing the battery.

NOTE

When powered, the

device will indicate

Z-Wave status with

colour of LED:

• Green - the device is

already added to the

Z-Wave network.

• Red - the device is

not added to any

Z-Wave network.