Operating Manual

ADVANCED PARAMETERS

76. Alarm signalization reactivation period

Parameter determines a time period after which an alarm will be turned

back on (in case it was turned o by parameter 75 setting). It will also

resend commands to 2nd and 3rd association groups as if the alarm

was detected again.

Available settings: 0 - alarm reactivation inactive

1-65535 - time in seconds

Default setting: 0 Parameter size: 4 [bytes]

77. Flood sensor functionality turned o

Allows to turn o the internal ood sensor. Tamper and built in tem-

perature sensor will remain active.

Available settings: 0 - Default ood sensor operation (ood detec-

tion, reactions)

1 - Built-in ood sensor TURNED OFF (does not

change its state in the main controller, does

not send alarm notications nor turn on/o

commands to 2nd/3rd association groups with

ood state changes. Always visible in the main

controller as turned o)

Default setting: 0 Parameter size: 1 [byte]

78. Associations in Z-Wave network security mode

This parameter denes how commands are sent in specied associa-

tion groups: as secure or non-secure. Parameter is active only in Z-Wave

network security mode. It does not apply to 1st “Lifeline “group.

Available settings: 0 - none of the groups sent as secure

1 - 2nd group ”Control” sent as secure

2 - 3rd group ”Alarm” sent as secure

4 - 4th group „Tamper” sent as secure

Default setting: 7 Parameter size: 1 [byte]

NOTE

In case a time period

set in parameter 76 is

shorter than the one

specied in parameter

75, the device will not

quiet the alarm, it will

remain active.