Operating Manual

ADVANCED PARAMETERS

63. Temperature indication using LED visual indicator

Parameter determines visual indicator’s operation. Setting to 0 turns

the temperature LED indication o, saving battery life.

Available settings: 0 - visual indicator does not indicate the

temperature

1 - visual indicator indicates the temperature

(blink) every Temperature Measurement Inter-

val (parameter 10, constant current and bat-

tery) and Wake Up Interval (battery mode)

2 - visual indicator indicates the temperature

continuously, only in constant power mode

Default setting: 2 Parameter size: 1 [byte]

73. Temperature measurement compensation

Parameter stores a temperature value to be added to or deducted

from the current temperature measured by internal temperature sen-

sor in order to compensate the dierence between air temperature

and temperature at the oor level.

Available settings: -10 000 to +10 000

Default setting: 0 (0.00°C) Parameter size: 2 [bytes]

74. Alarm frame sent to 1st and 4th Association Group activation

(MOVEMENT_TAMPER / BUTTON_TAMPER)

The device is able to report tamper alarms resulting from sensor’s

tilt/movement or TMP button state change (e.g. taking o the top

cover).

Available settings: 0 - tamper alarms inactive

1 - button tamper alarm active

2 - movement tamper alarm active

3 - button and movement tampers alarm active

Default setting: 2 Parameter size: 1 [byte]

75. Alarms signalization duration

The device is capable of automatically turning o alarm signalization

after a certain amount of time. Long lasting alarm may reduce battery

life, when constantly signalized.

The parameter determines time after which alarm will become “quiet”

- still active but the device will go into battery saving mode. Visual or

acoustic alarm will be reactivated after time specied in the parameter

76. When alarm status ceases, alarm will be turned o immediately.

Available settings: 0 - alarms active indenitely

1-65535 - time in seconds

Default setting: 0 Parameter size: 4 [bytes]

NOTE

Parameter 75 is ig-

nored when parame-

ter 2 is set to 0.