Operating Manual
15
ADVANCED PARAMETERS
Available settings: 0 - acoustic and visual alarms inactive
1 - acoustic alarm inactive, visual alarm active
2 - acoustic alarm active, visual alarm inactive
3 - acoustic and visual alarms active
Default setting: 3 Parameter size: 1 [byte]
7.
Requested dimming level / roller blind opening level when send-
ing turn on / open command to 2nd association group devices
Determines the requested “on” level to be sent to devices from 2nd
association group upon ood event.
Available settings: 1-99 - requested level
255 - turn a device on
Default setting: 255 Parameter size: 2 [bytes]
9. Deactivate turning o devices in 2nd association group & alarm
cancellation in 3rd group
This setting decides whether device turn o commands and alarm
cancellation notications will be sent to devices in 2nd and 3rd asso-
ciation groups (respectively)
Setting the parameter’s value to 0 disables sending these two com-
mands to associated devices. This means that these devices WILL NOT
be informed when the ooding has ceased. It is still possible to cancel
alarms in 3rd association group by choosing second (green) menu
position (see “Menu & visual indications” on page 10).
Available settings: 0 - alarm (ooding) cancellation inactive
1 - alarm (ooding) cancellation active
Default setting: 1 Parameter size: 1 [byte]
10. Temperature measurement interval
Time interval (in seconds) between consecutive measurements of
battery level and temperature (done by built-in temperature sensor).
If the temperature diers from previously reported by a value deter-
mined in parameter 12, it will be reported to the Z-Wave controller.
In battery mode more signicant battery level changes will be report-
ed. Short time intervals mean more frequent communication, which
results in shortened battery life.
After consecutive FAILED and SUCCESSFUL communication attempts,
the Sensor will go to standby mode.
Available settings: 1-65535 (in seconds)
Default setting: 300 (5min) Parameter size: 4 [bytes]
12. Temperature measurement hysteresis
Determines a minimum temperature change value (insensitivity lev-
el), resulting in a temperature report being sent to the main control-