FAQ

Home intelligence
www.manuals.baro.com
• Is it possible to easily check if the Flood Sensor has good Z-Wave range and can
communicate with the FIBARO System?
Yes, FIBARO Flood Sensor has a built-in Z-Wave controller’s range tester.
• Internal temperature sensor measures overstated temperature. Can I compensate
it?
Yes, parameter 73 stores a temperature value to be added to or deducted from the
current temperature measured, compensating the difference between air temperature
and temperature at the oor level.
• How many devices can be associated with the Flood Sensor?
FIBARO Flood Sensor allows for controlling 5 regular and 5 multichannel devices per
an association group, out of which 1 eld is reserved for the Z-Wave network main
controller.
• What is the Alarm Broadcast?
Broadcast mode allows to send alarms to all devices within the FIBARO Flood Sensor’s
range with a priority over other communications.
• Can I turn off the acoustic and visual signals?
Yes, you can disable them in parameter 2. Available settings:
0 – acoustic and visual alarms inactive
1 – acoustic alarm inactive, visual alarm active
2 – acoustic alarm active, visual alarm inactive
3 – acoustic and visual alarms active
• There was water detection, but the Flood Sensor is still detecting water. What
should I do?
You should edit parameter 1. It determines time period in seconds, by which a Flood
Sensor will retain the ood state, after the ooding itself has ceased.
• The Flood Sensor reports tilt when it is moved accidently. Can I turn of the tilt
sensor?
Yes, just edit parameter 74 and change its value to 0.
Still have questions? Contact us: support-usa@baro.com