User's Manual

ManualsBrandsFibar Group ManualsElectronicsFibaro Single Switch 2

OPERATING THE DEVICE

#5: Operating the device

Controlling the Switch 2 using a momentary switch

and parameter 20 set to 0:

1x click:

• Change the state of the connected load to the opposite one

(S1 switches 1st channel, S2 switches 2nd channel),

• Change the state of 2nd, 3rd (S1 switch), 4th and 5th (S2 switch)

association group to the opposite one.

2x click:

• Set maximum level of devices associated in 2nd, 3rd (S1 switch),

4th and 5th (S2 switch) group.

Hold:

• Start smooth control of devices associated in 3rd (S1 switch) and

5th (S2 switch) group.

Release:

• Stop smooth control of devices associated in 3rd (S1 switch) and

5th (S2 switch) group.

NOTE

Momentary switch

After releasing the

switch a spring auto-

matically pushes back

and disconnects the

switch)

Toggle switch

Operates as a two-po-

sition switch, it has no

spring that would set

one position of the

switch.

Controlling the Switch 2 using a toggle switch and parameter 20

set to 1:

Close switch contact:

• Turn ON the connected load (S1 switches 1st channel, S2 switches

2nd channel),

• Turn ON devices associated in 2nd, 3rd (S1 switch), 4th and 5th

(S2 switch) group.

Open switch contact:

• Turn OFF the connected load (S1switches 1st channel, S2switches

2nd channel).

• Turn OFF devices associated in 2nd, 3rd (S1 switch), 4th and 5th

(S2 switch) group.

Controlling the Switch 2 using a toggle switch and parameter 20

set to 2:

Change switch position once:

• Change the state of the connected load to the opposite one

(S1 switches 1st channel, S2 switches 2nd channel),

• Change the state of 2nd, 3rd (S1 switch), 4th and 5th (S2 switch)

association group to the opposite one.

Change switch position twice:

• Set maximum level of devices associated in 2nd, 3rd (S1 switch),

4th and 5th (S2 switch) group.

NOTE

Toggle switch and

parameter 20 set to 1:

State of the device

is synchronized with

state of the external

toggle switches.

Toggle switch and

parameter 20 set to 2:

State of the device is

reversed with every

change in state of

the external toggle

switch.