User Manual

6
OPERATING THE DEVICE
#4: Operating the device
Waking up the device:
The KeyFob needs to be woken up to receive information about the
new conguration from the Z-Wave controller, like parameters and
associations. Use 1st menu position (white) or press
and simulta-
neously to wake up the device.
Menu allows to perform Z-Wave network actions. In order to use the
menu:
1. Press
and simultaneously.
2. Press
or until LED indicates desired menu position with colour:
• White - wake up the device
• Green - learning mode (adding/removing)
• Cyan - check battery level
• Yellow - the device reset*
3. Press
to conrm selection, press to exit the menu.
4. LED will pulse twice with same colour as selected menu position
to conrm completing action.
Resetting the device to factory defaults:
Reset procedure allows to restore the device back to its factory set-
tings, which means all information about the Z-Wave controller and
user conguration will be deleted. There are two ways of resetting the
device:
Resetting the device using the menu:
1. Press
and simultaneously.
2. Press
or until LED glows yellow.
3. Press
.
Emergency resetting the device on start-up:
1. Remove the battery.
2. Hold
and , while inserting the battery.
Successful resetting will be conrmed by smoothly brightening and
dimming of the yellow LED colour.
NOTE
* Resetting the de-
vice is not available in
Lock Mode.
NOTE
Resetting the device is
not the recommend-
ed way of removing
the device from the
Z-Wave network. Use
the reset procedure
only if the primary
controller is missing
or inoperable. Certain
device removal can be
achieved by the pro-
cedure of removing
described in "Adding/
removing the device"
on page 5.
i
i