User's Manual
13
ADVANCED PARAMETERS
#9: Advanced parameters
The Door/Window Sensor allows to customize its operation to user’s
needs. Settings are available in the FIBARO interface as simple op-
tions that may be chosen by selecting the appropriate box.
In order to congure the Door/Window Sensor (using the Home Center
controller):
1. Go to the device options by clicking the icon:
2. Select the „Advanced” tab.
1. Operation mode
Parameter denes device operation mode.
Available settings: 0 - Door/Window Sensor or external alarm sensor
1 - external button
Default setting: 0 Parameter size: 1 [byte]
2. Door/Window or alarm status
Parameter denes state of the sensor when the magnet is close. If the
alarm sensor is connected, it determines the output type. Parameter
inactive in external button mode (parameter 1 set to 1).
Available settings: 0 - door/window closed
1 - door/window opened
Default setting: 0 Parameter size: 1 [byte]
Wake up interval
Available settings: 0 or 3600-64800 (in seconds, 1h - 18h)
Default setting: 21 600 (every 6 hours)
The Door/Window Sensor will wake up after each dened time inter-
val and always try to connect with the main controller. After a suc-
cessful communication attempt, the sensor will update conguration
parameters, associations and settings and will go into standby mode.
After failed communication attempt (e.g. lack of Z-Wave range) the
device will go into standby mode and retry to establish connection
with the main controller after the next time interval.
Setting wake up interval to 0 disables sending Wake Up Notication
frame automatically. Wake up may be still performed manually by a
single TMP button click.
Longer time interval means less frequent communication and thus a
longer battery life.
CAUTION
Do not install the
magnet if the de-
vice is not used as a
Door/Window Sensor,
as it might lead to the
malfunction of the
device.
!