User's Manual
11REGULATIONS
National regulations
This device complies with Part 15 of the FCC Rules
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including interference
that may cause undesired operation. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guar
-
antee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television recep
-
tion, which can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada (IC) Compliance Notice
This device complies with Industry Canada license-exempt RSSs. Operation
is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Cet appareil est conforme aux normes d’exemption de licence RSS d’Indus
-
try Canada. Son fonctionnement est soumis aux deux conditions suivantes
: (1) cet appareil ne doit pas causer d’interférence et (2) cet appareil doit
accepter toute interférence, notamment les interférences qui peuvent af
-
fecter son fonctionnement.
Legal Notices
All information, including, but not limited to, information regarding the
features, functionality, and/or other product specication are subject to
change without notice. Fibaro reserves all rights to revise or update its
products, software, or documentation without any obligation to notify any
individual or entity.
Fibaro and Fibar Group logo are trademarks of Fibar Group S.A. All other
brands and product names referred to herein are trademarks of their re
-
spective holders.
Note
Changes and modications not expressly approved by the manufacturer or
registrant of this equipment can void your authority to operate this equip
-
ment under Federal Communications Commission’s rules.
DGT Warning Statement
Article 12
Without permission, any company, rm or user shall not alter the frequen
-
cy, increase the power, or change the characteristics and functions of the
original design of the certied lower power frequency electric machinery.
Article 14
The application of low power frequency electric machineries shall not af
-
fect the navigation safety nor interfere a legal communication, if an inter-
ference is found, the service will be suspended until improvement is made
and the interference no longer exists.
第十二條
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用
者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。 第
十四條
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有
干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。 前項合
法通信，指依電信法規定作業之無線電通信。
低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電
機設備之干擾。