User Manual

9
REMOVING THE DEVICE
Removing (Exclusion) - Z-Wave device learning mode, allowing to
remove the device from existing Z-Wave network.
To remove the device to the Z-Wave network:
1. Place the Swipe within the direct range of your Z-Wave controller.
2. Set the main controller in remove mode (see the controller’s
manual).
3. Move and hold your hand close to the center of the pad.
4. If the device is battery powered, high pitched beep will signal
exiting the Standby Mode.
5. Loud sound sequence will conrm entering the menu, keep
holding your hand.
6. After hearing two short beeps (green indicator colour), withdraw
the hand and perform swiping up gesture to conrm selection
(two beeps will conrm validity).
7. Wait for the removing process to end.
8. Successful removing will be conrmed by the Z-Wave controller’s
message and sequence of 2 short beeps, pause, 1 short beep (red
visual indicator colour).
NOTE
Removing the Swipe
from the Z-Wave net-
work restores all the
default parameters of
the device.
i
NOTE
If the device is bat-
tery powered, high
pitched beep will sig-
nalize exiting from the
Standby Mode before
entering the menu.
i
#5: Removing the device