User's Manual

INSTALLATION

#4: Installation

Connecting the FIBARO Dimmer 2 in a manner inconsistent

with manual may cause risk to health, life or material

damage.

When connecting FIBARO Dimmer 2 act in accordance with the

following rules:

• Connect only in accordance with one of the diagrams

• Electrical installation must be protected by overcurrent protection

(fuse) of with a value not higher than 10A

• Dimmer 2 should be installed in a wall switch box compliant with a

relevant national safety standards and with depth no less than 2.4

inches (60 mm)

• Electrical switches used in installation should be compliant with the

relevant safety standards

• Length of wires used to connect the control switch should not

exceed 65 ft (20 m)

Installation of the FIBARO Dimmer 2:

1. Switch o the mains voltage (disable the fuse)

2. Open the wall switch box

3. Connect with one of the following diagrams:

DIMMER

Notes for the diagrams:

L - terminal for live lead

S1 - terminal for switch no. 1 (has the option of

entering the device in learning mode)

S2 - terminal for switch no. 2

Sx - terminal for power supply to the switch con-

nected to the Dimmer 2

N - terminal for neutral lead

- output terminal of the Dimmer 2 (controlling

connected light source)

B - service button (used to add/remove the device

and navigate the menu)