User's Manual

INSTALLATION

4. After verifying correctness of connection switch on the mains

voltage

5. Wait around 30s for the calibration process to end (see „Calibra-

tion” on page 15), light may blink during the process

6. After successful calibration the device will be turned o by default

7. Add the device to the Z-Wave network (see „Adding/removing the

device” on page 11)

8. Turn o the mains voltage, then arrange the device and its anten-

na in a wall switch box

9. Close the wall switch box and turn on the mains voltage

DIMMER

Wiring diagram no. 5 - momentary wall switches

connection

NOTE

It is not recommend-

ed to install dierent

types of wall switches

(momentary, toggle,

etc.) in a 3-way con-

nection.

Wiring diagram no. 4 - 3-way switch connection

DIMMER

1 3

Tips for arranging the antenna:

• Locate the antenna as far from metal elements as possible

(connecting wires, bracket rings, etc.) in order to prevent

interferences.

• Metal surfaces in the direct vicinity of the antenna (e.g. ush

mounted metal boxes, metal door frames) may impair signal

reception!

• Do not cut or shorten the antenna - its length is perfectly matched

to the band in which the system operates.

NOTE

After switching on the

mains voltage LED

indicator will signal

Z-Wave network in-

clusion state with a

colour:

GREEN - device added

RED - device not added

RED/GREEN ALTER-

NATELY- Z-Wave error