O P E R AT I N G MANUAL EN FIBARO BUTTON FGBHPB-101 CONTENTS #1: Description and features #2: Basic activation #3: Pairing the accessory #4: Functionality v1.
Important safety information ! Read this manual before attempting to install the device! Failure to observe recommendations included in this manual may be dangerous or cause a violation of the law. The manufacturer, Fibar Group S.A. will not be held responsible for any loss or damage resulting from not following the instructions of operating manual. The alarm functionality of devices is an additional feature increasing the comfort level of your home automation system.
#1: Description and features FIBARO Button is a HomeKit-enabled, compact, battery-powered wireless controller using Bluetooth® low energy technology. It allows you to control HomeKit accessories using Automations. Various actions may be triggered with one clicks, two clicks or by holding the button down. With its small design and wireless communication, the FIBARO Button can be conveniently mounted on any surface and in any position or location at home, e.g. beside the bed or under the desk.
#2: Basic activation 1. Press and turn the button counter-clockwise to open the casing. 2. Remove the battery blocker and check if the battery is placed correctly. 3. Press and turn the button clockwise to close the casing. 4. Pair the accessory (as described in "#3: Pairing the accessory"). 5. Install the accessory in desired location using the attached self-adhesive pad.
#3: Pairing the accessory 1. Open the Settings app on your iOS device. 2. Go to the Bluetooth® section, and turn the Bluetooth® on. 3. Place the accessory next to your iOS device. 4. Open a HomeKit compatible app of your choosing on your iOS device. 5. Open pairing window in your HomeKit app to detect available accessories. 6. Choose The Button you wish to pair. 7. You can identify it - The Button will triple beep 3 times. 8.
#4: Functionality i NOTE Automations require using Apple TV (4th generation) or iPad (iOS 10 or later) set as Home Hub. Detecting Button pushes: The Button detect if it was clicked one time, two times, held or released, then reports it to your iOS device. Automations can be created based on the detected action. Battery level measuring: The Button measures battery level every 24 hours and reports it to your iOS device.
#5: Reset Resetting the Button to factory defaults: Reset procedure allows to restore the accessory back to its factory settings including HomeKit pairing. 1. Click the Button exactly five times. 2. Press and hold the Button for at least 5 seconds. 3. Long beep will confirm resetting.
#6: Specifications ! CAUTION Using batteries other than specified may result in explosion. Dispose of properly, observing environmental protection rules. Specifications Power supply: 3.6V DC battery Battery type: ER14250 ½AA Battery life: est. 2 years (max. 10 pushes per day) EU standards compliance: RED 2014/53/EU RoHS 2011/65/EU Radio protocol: Bluetooth® low energy Radio frequency: 2.
#7: Regulations This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions: 1. This device may not cause harmful interference 2. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
FIBARO and Fibar Group logo are trademarks of Fibar Group S.A. All other brands and product names referred to herein are trademarks of their respective holders. Note Changes and modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate this equipment under Federal Communications Commission’s rules.
