User's Manual

Table Of Contents

PHYSICAL INSTALLATION

SENS 1

SENS 2

Extending Flood Sensor contacts with a wired probe:

NOTE

Mounting screws

shown in a diagram

are not included.

Choose a screw type

depending on the

building material it is

being attached to.

CAUTION

Sensor’s contacts are

dedicated to ood de-

tection only. Do not

connect external volt-

age!

#4: Physical installation

To install the Flood Sensor simply place it sensor on a surface prone

to ooding.

Three electrodes underneath the device should evenly touch the sur-

face.

NOTE

Sensor external probe

is not included.

If you want the accessory to be mounted on a wall or in a distance

from ooding source, sensor should be extended using an external

probe.

NOTE

Before completing

the installation it is

recommended to test

sensor’s operation by

placing the entire sen-

sor or sensor probe

onto water surface.