User guide

189
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
IF THE BATTERY IS FLAT
IMPORTANT The battery charging pro-
cedure is described only for information
purposes. This operation should be car-
ried out by Fiat Dealership.
Charging should be slow at a low amp rat-
ing for 24 hours. Charging for a longer
time may damage the battery.
VERSIONS WITHOUT
Start&Stop SYSTEM
(for versions/markets, where provided)
Charge the battery as follows:
❒ disconnect battery negative terminal;
❒ connect the charger cables to the bat-
tery terminals, observing the poles;
❒ turn on the charger;
❒ when you have finished, turn the charg-
er off before disconnecting the battery;
❒ reconnect battery negative terminal.
VERSIONS WITH
Start&Stop SYSTEM fig. 54
(for versions/markets, where provided)
Charge the battery as follows:
❒ proceed as follows: detach the con-
nector A (by pressing button B) from
sensor C for monitoring the status of
the battery installed on the battery neg-
ative pole D;
❒ connect the positive cable to the posi-
tive battery terminal E and the negative
terminal to the sensor D as shown in
the figure;
❒ turn on the charger. Turn the device off
after recharging;
❒ after having disconnected the recharg-
ing device, reconnect the connector A
to the sensor C as shown in the figure.
IMPORTANT Where relevant, switch the
electronic car alarm off with remote con-
trol (see “Alarm” in section “Dashboard
and controls”).
fig. 54
F0Q0762m
157-192 BRAVO GB.qxd 4-04-2011 11:56 Pagina 189