User Manual
5
1 Source signal inputs
2 Speakers outputs for the right channel
3 Speakers outputs for the left channel
4 Socket for the main fuse
5 IEC power supply cord socket
6 Mains switch
7 Signal ground switch
The gure above shows the rear panel view of the amplier, together with a description of the inputs and outputs allowing for
connection of the other elements of your audio system.
Follow the instructions below to connect your sound system correctly.
Check the impedance of the speaker set. Connect the speaker cable to the appropriate terminals on the rear panel of the
amplier. Depending on the impedance of the speakers, connect it to the terminal marked either 4 Ω or 8 Ω. If your speaker
impedance is 6 Ω - connect the speaker wire to the terminal 8 Ω.
Connect the signal source to the amplier inputs IN1, IN2 or IN3. Select the source of input signal by rotating the input selector
located on the front panel of the amplier. In order to achieve the highest sound quality, use only high-quality RCA cables.
Pay attention to the proper connection and distinction of the right (R) and the left (L) channels. For the best sound quality,
we suggest using the Fezz FAC 01 interconnect cable dedicated for Fezz Audio vacuum tube ampliers.
Make sure that the amplier is switched o. Connect the power cord to the IEC socket on the rear panel of the amplier.
The amplier is designed to operate at a rated voltage of 230V / 50-60Hz. Connecting the device to a mains network with
incorrect parameters can lead to damage that is not covered by manufacturers warranty.
STEP 1 SPEAKERS CONNECTIONS
STEP 2 AUDIO SIGNAL SOURCES CONNECTIONS
STEP 3 POWER CORD CONNECTION