User Guide

8
Power board test
If the lights on the Power Line Adapter units don’t light up after connecting the adapters, you can run a test
through a power board to check if the adapters are working correctly.
To run the power board test:
If the adapters work correctly through the power board, they are not faulty which means that any issues you had
may have been caused by the power circuit, power point, or the way in which you connected the adapters.
Plug both adapters into a small power board.
Plug the Ethernet cable for both adapters, into an Ethernet compatible device.
For example, connect the Ethernet cable from adapter 1 to your modem/router
and connect the Ethernet cable from adapter 2 to your Fetch Box, laptop, or
printer.
Make sure each of the Ethernet connected devices are powered on.
If all three lights on the adapters turn on, it means they’re not faulty. It’s normal
for the lights to blink or change colour (Page 10).
1
2
3
4
Note
This setup is for testing purposes only,
so after testing and confirming that
the Power Line Adapters are working,
please remove the power board from
your setup.