User Guide

5
Connect your Fetch Box to
modem with Power Line Adapters
Make sure you’ve read the Fetch Quick Start Guide before following the steps below as
connecting your Fetch Box to your modem is just one stage in setting it up.
The Power Line Adapters should be plugged directly into the wall socket; if using a double
adapter or power board in your setup, see “Important setup advice” on Page 4.
3
Plug one Power Line Adapter into an electrical socket near your broadband modem.
Plug one end of an Internet Ethernet cable into the port on the Power Line Adapter unit.
Plug the other end into a free port on your broadband modem.
Plug the other Power Line Adapter into an electrical socket near your TV and Fetch Box.
Plug one end of an Internet Ethernet cable into the port on
the Power Line Adapter unit.
Plug the other end into the port labelled INTERNET on the
back of your Fetch Box.
If you haven’t already done so, make sure the electrical outlets
for both adapters are turned on. The Power lights on the
adapters will turn on.
Make sure your modem and Fetch Box are turned on. When both adapters have a
connection with each other, the Data lights will turn on. When data is transmitting
between the adapters, the Data lights will turn green. The Ethernet light will flash when
data is successfully transmitting (see Page 10).
1
2
3
4
5
6
7
8
Note
Your two Power Line Adapter
units are already paired with each
other. If you run into any issues,
see “Troubleshooting Power Line
Adapters” (Page 6).
Room 1
Outside
Broadband
Connection
Fetch
Signal
Fetch
Signal
TV Aerial
AV
Cable
Normal
Broadband
Use
Broadband
Modem
Room 2
PLA Device