Operation Manual
10
MXC
GB
6Operation
6.1 Charging the battery pack [1]
Charge only battery packs that are desig-
nated for use with the charger. (see Techni-
cal data)!
The LED
[1-3]
on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Battery pack will be charged with max. current.
LED green - flashing slowly
Battery Pack is charged to 80 % and will be charged
with further reduced current.
LED green - lit continuously
Battery pack is fully charged.
LED red - lit continuously
Battery temperature is outside the permitted range
(0 °C to 45 °C).
LED red - flashing
General fault display, e. g. incomplete contact,
short circuit, battery pack faulty, etc.
6.2 Charger wall mount
The charger MXC has two elongated holes on its
back. It can be mounted on a wall using two screws
(e.g. round head or flat head screw with shank di-
ameter of 5 mm) (see Fig.
[1]
).
7 Service and maintenance
Observe the following instructions:
– Keep the air slits on the machine and the charger
free and clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
8 Accessories
Use only original Festool accessories and Festool
consumable material intended for this machine be-
cause these components are designed specifically
for the machine. Using accessories and consum-
able material from other suppliers will most likely
affect the quality of your working results and limit
any warranty claims. Machine wear or your own
personal workload may increase depending on the
application. Protect yourself and your machine, and
preserve your warranty claims by always using
original Festool accessories and Festool consum-
able material!
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
9 Disposal
Do not throw the tool in your household waste!!
Dispose of machines, accessories and packaging at
an environmentally responsible recycling centre.
Observe the valid national regulations.
EU only:
European Directive 2002/96/EC stipulates
that used electric tools must be collected separate-
ly and disposed of at an environmentally responsi-
ble recycling centre.
10 Warranty
We offer a warranty for material and production de-
fects for all our tools in accordance with the locally
applicable legal provisions, but for a minimum of 12
months. Within the EU member states, the warran-
ty period is 24 months (verification through invoice
or delivery note). Damage caused by the operator,
natural wear, overloading, incorrect handling or
through the use of the equipment not specified in
the operating manual, or damage which was known
at the time of purchase, is not covered by the war-
ranty. Furthermore, damage caused by the use of
non-original accessories and consumable materi-
als (e.g. sanding pads) is also excluded.
Complaints can only be accepted if the tool is re-
turned while still assembled to the supplier or an
authorised Festool Customer Service workshop.
Keep the operating manual, safety instructions,
spare parts list and purchase receipt in a safe
place. Otherwise the current warranty conditions of
the manufacturer shall apply.
Note
Due to continuous research and development work,
we reserve the right to make changes to the techni-
cal content of this documentation.
WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.
In North America, only Festool machines with
the voltage specifications 120 V/60 Hz may be
used.