Specifications

Mobile dust extractors
CT MIDI I 470 × 320 × 495 mm (18.5 in. x 12,6 in. x
19.5 in.)
Weight CT MINI I 11.0 kg (24.3 lbs)
CT MIDI I 11.3 kg (24.9 lbs)
6 Intended use
The dust extractor is designed for use as speci
fied for the aspiration and evacuation of non-
noxious dusts, dirt, sand, shavings etc..
The dust extractor is designed as specified for
vacuuming water.
The dust extractor is designed for household,
commercial or both use.
The dust extractor is designed for outdoor use
and indoor storage.
This extractor has been tested in accordance
with OSHA 1926.1153. The HEPA Filter is tested
and certified in accordance with IEST RP-
CC-001, to filter and exhaust air particles to 0.3
microns with at least 99.97 % efficiency with no
bypass leakage.
WARNING
The user will be liable for damage due to im
proper use.
7 Commissioning
WARNING
Unauthorised voltage or frequency!
Risk of accidents
► Observe the specifications on the ma
chine's name plate.
► Observe country-specific regulations.
7.1 Initial commissioning
► Insert the filter/disposal bag [2].
► Fit the cord holder [3].
► Connect the suction hose [3]
.
2
3
7.2 Extension Cord
If an extension cord is required, it must have
sufficient cross-section to prevent an excessive
drop in voltage or overheating. An excessive
drop in voltage reduces the output and can lead
to failure of the motor. The table below shows
you the correct cord diameter as a function of
the cord length for this tool.
Total Extension
Cord Lenght
(feet)
25 50 100 150
Cable size (AWG) 14 12 not recommended
Use only U.L. and CSA listed extension cords.
Never use two extension cords together. In
stead, use one long one.
The lower the AWG number, the
stronger the cord.
7.3 Connecting the mobile dust extractor
WARNING
Risk of injury from uncontrolled tool start-
up
► Before switching on ensure that the con
nected tool is switched off.
English
9