User Manual
3. Installation
3−3
Festo P.BE−SPC200−EN en 0901d
Contents of this chapter This chapter contains general instructions on installing the
pneumatic axis. It also deals with the installation of the
SPC200 basic unit with the following components and
modules:
Power supply module type SPC200−PWR−AIF
Diagnostic module type SPC200−MMI−DIAG
I/O module type SPC200−DIO
Analogue input module type SPC200−2AI−U
Sub−controller module type SPC200−SCU−AIF
Axis interface type
SPC−AIF−...
I/O function module type SPC−FIO−2E/2A−M8
This chapter also contains important basic rules on setting up
an axis interface string.
Further information Installation instructions on special drives can be found in
appendix A.
Installation instructions on field bus modules as well as mod
ules for coupling electric axes can be found in the manual for
the
relevant module.
Instructions on fitting electromechanical axes, power con
trollers and sensors can be found in the documentation for
the relevant component.