User Manual

1. Summary of components
1−27
Festo P.BE−SPC200−EN en 0901d
Theme Functions Control
panel
WinPISA
Configuration  Entering axis data
 Entering application data
 Entering controller data

1)

1)




Programming  Entering programs
 Entering positions
 Teach Editor for positions
 Project backup functions
 New NC syntax and new NC commands










2)
Commissioning  Test functions for components
 Program test in single steps
 Extended test functions
 Uploading/downloading programs
 Starting and stopping programs










Service  Updating the SPC200 firmware by downloading
 Reading out statistic diagnostic data




Analysis and
Optimization
 Graphical representation of measured data
 Entering extended system data




1)
If they correspond to operating system version 3.8, see also page XVI
2)
Only in conjunction with operating system versions 4.6 and WinPISA from version 4.3 onwards