User Manual

D. Index
D−19
Festo P.BE−SPC200−EN en 0901d
P
Parameters of a positioning axis 4−17 . . . . . . . . . . . . . . . . . . .
Application data 4−19 , 4−21 . . . . . . . . . . . . . . . . . . . . .
. . . .
Axis data 4−18 , 4−20 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Controller data 4−22 . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
Performance limits of the drives 1−8 . . . . . . . . . . . . . . . . . . . .
Pictograms
XIV . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Piston rod drives 1−7 . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
Planning (notes) 1−8 . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . .
Points of reference
(see also Dimensional reference system) 6−20 . . . . . . . . .
Position actual value, Display with the control panel 6−48 . .
Position axis
During commissioning (control panel) 4−36 . . . . . .
. . . . . .
Starting with the control panel 6−54 . . . . . . . . . . . . . . . . . .
Position list (position register) 1−30 , 7−18 . . . . . . . . . . . . .
. .
Position register 7−18 , 7−51 , 7−52 , 7−77 . . . . . . . . . . . . . . . .
Input with control panel 6−42 . . . . . . . . . . . . . . . . . . .
. . . . .
Teach with control panel 6−43 . . . . . . . . . . . . . . . . . . . . . . .
Position value
Add position value and position register
(NC command G29) 7−52 . . . . . .
. . . . . . . . . . . . . . . . . . .
Load into position register
(NC command G28) 7−51 . . . . . . . . . . . . . . . . . . . . . . .
. .
Position−dependent switch to next record
(NC command G25) 7−44 . . . . . . . . . . . . . . . . . . . . . . . . . . .
Positioning
At defined speed (NC command G02) 7−37 . . . . .
. . . . . . . .
At defined speed (nominal value ramp)
(NC command G01) 7−35 . . . . . . . . . . . . . . . . . . . . . . . . .
At highest possible speed (point to point)
(NC
command G00) 7−31 , 7−33 . . . . . . . . . . . . . . . . . . . .
Position adjustment
(NC command M13) 7−74 . . . . . . . . . . . . . . . . . . .
. . . . . .
Presettings 7−11 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
With Start/Stop frequency
(NC command G02) 7−39 . .
. . . . . . . . . . . . . . . . . . . . . . .