User Manual

D. Index
D−14
Festo P.BE−SPC200−EN en 0901d
Instructions on editing with the control panel 6−33 . . . . . . . .
Integer operands (integer variables) 7−14 . . . . . . . . . . . . . . .
Integer variables 7−14 . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . .
J
Jump instruction (NC command E05) 7−84 . . . . . . . . . . . . . . .
L
LED on the axis interface 8−6 . . . . . . . . . . . . . . . . . . . . . . . . . .
LED on the function I/O module 8−7 . . . . . . . . . . . .
. . . . . . . .
Load actual value (= actual position) into the
position register (NC command M38) 7−77 . . . . . . . . . . . . .
Load subroutine (NC command L) 7−82 . . . . . . . . .
. . . . . . . . .
Load supply
External 3−53 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Missing
4−13 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lower software end position
Setting with the control panel 6−21 . . .
. . . . . . . . . . . . . . . .
Setting with the control panel (stepping motor) 6−23 . . . .
M
Mass, Setting with the control panel. see Mass load. . . . . . .
Mass load (definition) 3−12 . . . . . . . . . . . . . . . . . . . . . . . . . . .
Maximum permissible mass load
3−15 . . . . . . . . . . . . . . . .
Maximum workpiece mass 3−14 . . . . . . . . . . . . . . . . . . . . .
Setting with the control panel 6−19 . . .
. . . . . . . . . . . . . .
Minimum mass load 3−13 . . . . . . . . . . . . . . . . . . . . . . . . . . .
Minimum permissible mass load 3−15
. . . . . . . . . . . . . . . . .
Total moving mass without workpiece 3−12 . . . . . . . . . . . .
Setting with the control panel 6−19 . . . . . . . . . .
. . . . . . .
Workpiece mass in initial state 3−14 . . . . . . . . . . . . . . . . . .
Mass load instructions for the DSMI A−28 . . . . . . . . . . .
. . . .
Mass moment of inertia 3−15 . . . . . . . . . . . . . . . . . . . . . . . . . .
Setting with the control panel 6−19 . . . . . . . . . .
. . . . . . . . .