User Manual

D. Index
D−5
Festo P.BE−SPC200−EN en 0901d
Axis structure of the pneumatic drives
DGP(I)(L)−... (drive without piston rod) A−3 . . . . . . . . . . . . .
DNC−... (standard cylinder, piston rod drive) A−10 . . . . . . .
DNCI−... (standard cylinder,
measuring system integrated) A−31 . . . . .
. . . . . . . . . . . .
DNCM−... (standard cylinder,
measuring system built on) A−17 . . . . . . . . . . . . . . . . . . .
DSMI−... (rotary drive,
measuring system integrated) A−24 . . . . .
. . . . . . . . . . . .
Axis type, Supported NC commands 7−30 . . . . . . . . . . . . . . .
B
Base fastening (drives) A−14 , A−21 , A−36 . . . . . . . . . . . . . . .
Basic rules for installation 3−53 . . . . . . . . . . . . . . . . . . . . . . .
.
Basic setting on the control panel 6−6 . . . . . . . . . . . . . . . . . . .
Basics of controlling pneumatic axes B−3 . . . . . . . . . . . . . . . .
1−bit
operands 7−14 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Buttons, Operating functions of the control panel 6−4 . . . . . .
C
Cable cross−sectional area, Calculation C−14 . . . . . . . . . . . . .
Cable length (permissible), Calculation C−14 . . . . . . . . . . . . .
Checking the pneumatic tubing 4−27 . . . . . . . . . .
. . . . . . . . .
CLK_A/B signal (Record Select)
Definition 5−22 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Pin
assignment 3−43 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Sequence diagram 5−19 . . . . . . . . . . . . . .
. . . . . . . . . . . . . .