User Manual

1. Summary of components
1−21
Festo P.BE−SPC200−EN en 0901d
Maximum two axis interface strings and therefore up to four
pneumatic axes are possible (X, Y, Z, U) per SPC200. The sec
ond axis interface string is connected via the sub−controller
module type SPC200−SCU−AIF, which takes control of the
positioning of the further axes. Modules for connecting elec
tric axes can then be
installed.
If modules for connecting further pneumatic or electric axes
are fitted, the following applies:
 Axis identifiers (X, Y, Z, U) are distributed automatically in
ascending order without gaps from left to right on the
installed modules.
On the axis interface string the first axis receives the
lower−value axis identifier, the second axis the
higher−
value axis identifier.
1
23 1 2 3 4
1 Axis interface of the X−axis
2 Axis interface of the Y−axis
3 Axis interface of the Z−axis
4 Stepping motor controller of the U−axis
Fig.1/8: Assignment of axis identifiers (examples 2 and 3)