User Manual
A. Notes on installing the pneumatic components
A−37
Festo P.BE−SPC200−EN en 0901d
Please note
If there is too much play in the coupling between the mass
load and the drive this may cause:
noise due to knocking on the connecting elements
high wear on the connecting elements
bad running behaviour
bad positioning accuracy
in some cases to faults in identification travel.
Make sure that there is as
little play as possible between
the connecting elements.
Warning
Lateral loads and torques produce incorrect measured
results and can even damage the measuring system.
· Use an external guide for the mass load in order to pre
vent lateral loads and torques on the double piston rod.