User Manual
1. Summary of components
1−14
Festo P.BE−S PC200−EN en 0901d
Components You will require the following components for setting up a
pneumatic axis:
the SPC200 axis controller
an axis interface type SPC−AIF−...
a proportional directional control valve
typeMPYE−5−...−010B
a measuring system type MLO−POT−...−TLF,
typeMLO−POT−...−LWG or type MME−MTS−...−TLF−AIF or a
drive with integrated measuring system
a permitted drive
if necessary, further components for the drive, e.g. a
mechanical
guide, a coupling etc. (see appendix A.)
a service unit with 5 m filter
a 24 V DC power supply
if necessary, components for a pneumatic emergency
stop circuit.
The SPC200 Smart Positioning Controller takes control of the
following tasks:
specification of the nominal positions by positioning
control
comparison of the nominal and actual positions
and posi
tioning control by means of the proportional directional
control valve (status control)
optimization of the controller behaviour by parameter
adaptation
control of the peripherals via digital inputs and outputs
and sequence control.