User Manual

8. Diagnosis and error treatment
8−5
Festo P.BE−SPC200−EN en 0901d
Reaction Sequence Operating status Eliminating faults
ERROR LED
ON
OFF
 Switch−on phase (3...4 seconds)
or
 Hardware fault, SPC200 is not
ready for communication
· None
· Servicing required
ON
OFF
No internal fault registered None
ON
OFF
 Lights up briefly once when the
device is switched on
None
Flashing sequence according to the
fault class with a 1−second break
 Flashes once (fault class 1)
Initialization fault
 Flashes twice (fault class 2)
reserved
 Flashes three times (fault class 3)
User data damaged
 Flashes four times (fault class 4)
Hardware fault during running
time
 Flashes five times (fault class 5)
Sequence control fault
 Flashes six times (fault
class 6)
Fault in positioning task
 Flashes seven times (fault 7)
Pre−parametrizing fault
 Does not flash (fault class 8)
 Flashes nine times (fault class 9)
Trace fault
 Flashes continuously without
break Firmware deleted by user
· Install components and
modules correctly or replace
defective module
1) 2)
· (Reserved)
· Carry out Data Reset and
enter or load data again
1) 2)
· Read out fault message and
eliminate fault
1)
· Read out fault message and
eliminate fault
1)
· Read out fault message and
eliminate fault
1)
· Read out fault message and
eliminate fault
1)
· None
· Carry out Data Reset and
enter or load data again
1) 2)
· Load firmware
1)
Read out fault message and eliminate fault (see section 8.2)
2)
Or servicing required