User Manual

6. Operating the SPC200 with the control panel
6−40
Festo P.BE−S PC200−EN en 0901d
When a program has been selected, the program number will
be displayed in the first three columns (here P03). The first
NC record of the program is shown after this, e.g.
P03:N000 G00 *
X+0100.00
The cursor is positioned on the identifier for the NC record
number (here N
000). With the buttonsvVyou can page
through all the NC records of the program.
Note when programming multi−axis systems that, for reasons
of space, only the parameter for the currently selected axis
can be displayed.
Instructions on editing can be found in chapter 6.3.2.