User Manual

6. Operating the SPC200 with the control panel
6−34
Festo P.BE−S PC200−EN en 0901d
· If the cursor is positioned on an NC word, an NC word will
be selected with vV.
· If the cursor is positioned on a figure, the figure value will
be increased or decreased with vV.
· If the cursor is positioned on the axis identifier, one of the
existing axes will be selected with vV.
· With positioning commands, one of the following char
acters can be selected on the right next to the axis ident
ifier:
Sign
Meaning
+ Positive position value (e.g. X+0100.00)
− Negative position value (e.g. X−0100.00)
@ Number of the position register (e.g. X@10)
* Axis not relevant (e.g. Y*; Y−axis not relevant)
If the character * is selected, the command programmed in
the current line for the selected axis is not relevant, e.g.:
P03:N001 G00 G90
Y*
Conclude entry In order to conclude the entry of an NC record or program,
the cursor must be positioned on an NC command, para
meter or operand. The NC record is concluded with the Enter
button. Program entry is concluded with the Esc button.