User Manual

6. Operating the SPC200 with the control panel
6−15
Festo P.BE−SPC200−EN en 0901d
With the buttons vV you can now select the axis, the para
meters of which you wish to modify. When the axis has been
selected, the bottom line will show the current parameter
setting.
In order to modify a parameter, position the cursor on the
desired figure of the displayed parameter with the
buttons
{ }. With the buttons vV you can now modify the figure.
If you modify a parameter value, the character ? will be
shown in the bottom line.
CYL. TYPE
X: 1
1
2
3
5
Enter
CYL. TYPE
X: 2
?
CYL. TYPE
X
: 2
1 Character flashes (here underlined) = current cursor
position
2 Identifier for value modification
3 New value accepted (? No longer visible)
Fig.6/7: Set parameter values