User Manual

6. Operating the SPC200 with the control panel
6−6
Festo P.BE−S PC200−EN en 0901d
In the basic setting the control panel shows the following
message:
EnterEsc
SPC200 Vnnn X
SELECT WITH <>
12
3
1
Operating system version of the SPC200 (nnn = version
number); the dot after the main version identifier is not
shown due to lack of space; nnn corresponds to n.nn
2 Currently configured axes (here X−axis)
3 Reference line: With{ }you can select your menu
Fig.6/2: Basic setting on the control panel
By pressing the Esc button several times you can access the
basic setting. A special procedure is only required for exiting
the Program Editor (see chapter 6.3.1).
In the basic setting the control panel offers eight menus for
selection.
The following diagram gives an overview of the
menu structure and menu commands on the control panel: