User Manual

4. Commissioning
4−16
Festo P.BE−S PC200−EN en 0901d
In this case the actual configuration of the SPC200, as well as
the configuration on the axis interface string, is not the same
as the saved nominal configuration. Proceed as described in
section 4.3.1 under Save hardware configuration".
If there are no faults, the POWER LED will light up and the
control panel
will show the basic setting, see section 6.1,
Fig.6/2.
The SPC200 is then ready for commissioning which you can
carry out with the control panel or with the WinPISA software
package.