User Manual
3. Installation
3−41
Festo P.BE−SPC200−EN en 0901d
Addressing
The assignment of the I/O address range depends on the
configuration of the SPC200. If a field bus module is in
stalled, the address range 0.0 ... 0.9 will remain unassigned.
The assignment of the I/O addresses for configurations with
and without field bus module is shown in the following table:
Configuration without
field
bus module
Configuration with
field bus module
Maximum address range
First I/O module I0.0...I0.9
1)
Q0.0 ... Q0.7
1)
I/O module on the first axis interface string I1.0...I1.15 Q1.0 ... Q1.15
Second I/O module First I/O module I2.0...I2.9 Q2.0 ... Q2.7
I/O modules on the second axis interface string I3.0...I3.15 Q3.0 ... Q3.15
Third I/O module Second I/O module I4.0...I4.9 Q4.0 ... Q4.7
Fourth I/O module Third I/O module I5.0...I5.9 Q5.0 ... Q5.7
Field bus module I10.0...I13.15
2)
Q10.0 ... Q13.15
2)
1)
Address range is not available if a field bus module is used
2)
Address range is not available without a field bus module
If a field bus module is not installed, certain I/Os on the first
identified I/O module are pre−assigned depending on the
operating mode.