User Manual
3. Installation
3−35
Festo P.BE−SPC200−EN en 0901d
3.5.3 Connections of the diagnostic module
For commissioning, programming and diagnosing, you will
require a diagnostic module type SPC200−MMI−DIAG. The
diagnostic module offers the following serial interfaces:
a connection for control panel type SPC−MMI−1.
a connection for a PC or for control panel type
SPC200−MMI−1F. This serial interface is on a 9−pin sub
min−D plug and complies with standard RS232.
The serial interface is operated with the following settings:
Baud rate: 9.6 ... 115.2 kBaud
Data bits: 8 bits
Parity: even
1 stop bit
No handshake
In order to connect a PC you will require:
a screened connecting cable (e.g. Festo diagnostic cable
type KDI−PPA−3−BU9)
a PC with serial interface (RS232) and installed
programming and commissioning software WinPISA
typeP.SW−WIN−PISA−....