User Manual

SLG−Z−...
Festo SLG−Z−... 0512a English
21
Both end stops (A) of the SLG−... must
then be removed and fitted again at the
same height in the groove (B) of the
fastening rail.
2. Fasten the cushioning support with cen
tring pins and the fastening screw sup
plied to the slide of the linear drive (e.g.
type SLG−...).
Make sure that the alignment
is correct. If
fitted correctly, the cushioning support
will be below the edge of the slide of the
SLG−... (see Fig. 11).
S Fasten the fastening rail type SLG−S−... as
follows:
Place the fastening rail type SLG−S−... on
the profiled edge (C), position it with
dowel pins (D) and tighten with screws in
all the
fastening holes. The supporting
surface must be level (see operating in
structions for type SLG−...).
The tightening torques are shown in the
table below:
Fig.10
(A)
(B)
Fig.11
d
Fig.12
(C)
SLG−S−...
Fig.13
(D)