User Manual

SLG−...
Festo SLG−... 0802d English
23
S Fasten the component as in Fig.9.
Component supported
Points
Minimum distance: every 100 mm
Surface
Minimum evenness
Fig.9
If the minimum distances are not observed,
an individual functional check may be necess
ary.
S Place the work load on the slide as fol
lows:
 The tilting torque of force F parallel to
the cylinder axis and distance a should
remain as small as possible.
 Mass moments of interia occurring in a
dynamic application should
be calcu
lated, especially with changing loads.
S Select the screw for fastening the work
load with maximum screwing depth as in
Fig.11 / Fig.12.
j
8 12 18
L
6
4 mm 5 mm 8 mm
j
1
M4 M4 M5
Fig.12
Fig.10
Fig.11