S Instruction Manual
Quickstepper
Festo FSS−12−C 0410a English
23
S Observe the specifications applicable to your location, as well as all local and
national laws and regulations.
S Use only non−lubricated compressed air.
S Exposure to external impact can result in
errors. Do not allow objects to fall on the
product.
S Observe the ambient conditions at your
location.
S Make sure there is a supply
of correctly
prepared compressed air (chapter 13).
S Use the product in its original state. Un
authorized modification is not permitted.
S Remove the packing except for the adhes
ive labels on the compressed air connec
tions (to prevent dirt from entering).
The packing is intended for recycling (except
for: oiled paper which must be disposed
of).
6 Fitting
Fitting mechanical components
Attach the product on the front panel, front doors, side of the cabinet or in the
control cabinet.
6.1 Fitting on the front panel, front doors and side of the cabinet
1. Prepare a square cutout on the
surface. Fitting dimensions: front frame
92x92mm³, front plate thickness max. 13 mm.
2. Place the front frame FSS−F−12 (Fig.9) in the prepared front panel cutout from
the outside.
Fig.5
Fig.6
Fig.7
LF−... LR−... LD−...
Fig.8