Instruction Manual

3. Installation

3−5

Festo P.BE−CPX−SYS−EN en 0902e

Pre−assembling the plugs

and cables

Connect the plugs and cables as follows (example):

1. Open the plugs/sockets as follows:

· Power supply socket:

Insert the mains power socket into the operating volt

age connection of the CPX terminal. Unscrew the

housing of the socket.

Then remove the connecting part of the socket, which

is inserted in the operating voltage connection.

· Fieldbus socket and sensor plug (only with PG...):

Loosen the centre knurled nut.

1 Cable

2 Strain relief

3 Housing

4 Connecting part

Fig.3/1: Individual parts of the socket and cable exit

2. Open the strain relief on the rear part of the housing.

Then pass the cable through.

3. Remove 5 mm of insulation from the end of the conduc

tors and fit cable−end sleeves on the stranded wires.

4. Connect the ends of the conductors.