Instruction Manual

2. Assembly

2−12

Festo P.BE−CPX−SYS−EN en 0902e

Dismantling Remove the electric modules or interlinking blocks as follows

(see also following Fig.2/5):

1. Unscrew and remove completely the tie rod screws in the

left−hand end plate (see Fig.2/2). The interlinking blocks

are now held together only by the electrical plug con

nectors.

2. Remove the left−hand end plate from the tie rods.

3. To remove the

interlinking blocks:

Loosen the electrical plug connectors on the relevant in

terlinking block by taking the interlinking block apart

carefully and without tilting it.

4. Pull the loosened interlinking blocks away from the tie

rod.

5. To remove a tie rod:

With the aid of a suitable tool, e.g. a screwdriver, remove

the appropriate fastening and locking

plate in the pneu

matic interface or in the right−hand end plate (see

Fig.2/5).

1 Screwdriver

2 Fastening plate

and locking plate

in the pneumatic

interface or the

right−hand end

plate

Fig.2/5: Fastening plate and locking plate in the pneumatic interface